2002 MITSUBISHI MIRAGE 2DR COUPE
Security
Battery WHT + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK (-) (-) 2 PIN DOMELAMP PLUG-TOP LEFT FUSEPANEL
TrunkTrigger GRN/RED (-) TRUNK LIGHT
FactoryAlarmDisarm N/A
FactoryAlarmArm N/A
ParkingLights GRN/WHT (+) 13 PIN PLUG ABOVE FUSEPANEL
Remote Start
Battery WHT + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BLK/RED (-) TOP OF TRANSAXLE ON DRIVER SIDE
Tach WHT (-) AT COIL
SpeedSense YEL (AC) PASS KICK YEL 22 PIN CONN POS 18
ParkingLights GRN/WHT (+) 13 PIN PLUG ABOVE FUSEPANEL
BrakeLights GRN (+) (+) AT BRAKE SWITCH
ReverseLights RED/BLU (+) TOP OF TRANSAXLE ON DRIVER SIDE
Horn GRN/RED (-) LOCATED AT HORN
Doorlocks / Window
PowerUnLock LT.GRN/BLK (-) INTO BACK OF FUSEPANEL
PowerLock BLU/WHT (-) (-) DOOR LOCK MODULE BUILT
DriverDoorMotor01 BLU/BLK (+) UNDER DASH ON LEFT AT (ETACS)
DriverDoorMotor02 BLU/RED (+) UNDER DASH ON LEFT AT (ETACS)
LeftFrontWindow01 LF-RED/BLK(+)
RightFrontWindow01 RF-YEL/BLU)LR-RED/WHT)RR-RED
/BLU)EACHDOO
LeftRearWindow01 LF-GRN/BLK(+)
RightRearWindow01 RF-GRN/YEL)LR-GRN)RR-GRN/WH T)EACH DOOR
Convenience
HeadLights RED/WHT (-) (-) HEADLIGHT SWITCH
TrunkRelease N/A
Mobile Audio / Video
Battery WHT + (+) IGN. HARNESS
Accessory01 BLU/WHT + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRN/WHT (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
